The thermal models contained within this compressed file are property of 
Texas Instruments are provided without warranty and subject to change without 
notice, specifications are subject to change.  The included models are
designed to work with Mentor Graphics(R) Flotherm and have been tested on
version 9.2 only.  The included models support the following devices utilizing
the 23mm FCBGA package only:
	
	AM5716
	AM5718

It is the responsibility of the end user of these files and application
hardware to assure that each device does not exceed the allowable thermal
conditions established and documented within each respected application note
or data manual.

When no data manual exists, the maximum allowable junction temperature shall
not (under no condition) exceed 90°C, failure to comply with this requirement
will reduce device reliability and void any device warranty. 

The models provided include the Delphi model, and standard 2R model. The 
standard 2R model is two resistor model based on the junction-to-board 
(theta-jb) and the junction to case (theta-jc) parameters provided in the data 
manual. 

2R models are only valid for a rough estimate of the thermal solution. Final 
solutions should be created using the Delphi model for best results.